Clear Sntp Client; Set Sntp Server - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Simple Network Time Protocol (SNTP)
Mode
Switch command, Read‐Write.
Example
This example shows how to enable SNTP in broadcast mode:
Matrix(rw)->set sntp client broadcast

clear sntp client

Use this command to clear the SNTP client's operational mode.
Syntax
clear sntp client
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to clear the SNTP client's operational mode:
Matrix(rw)->clear sntp client

set sntp server

Use this command to add a server from which the SNTP client will retrieve the current time when
operating in unicast mode. Up to 10 servers can be set as SNTP servers.
Syntax
set sntp server ip-address [precedence]
Parameters
ip‐address
precedence
Defaults
If precedence is not specified, 1 will be applied.
Mode
Switch command, Read‐Write.
13-4 SNTP Configuration
Specifies the SNTP server's IP address.
(Optional) Specifies this SNTP server's precedence in relation to its
peers. Valid values are 1 (highest) to 10 (lowest).
clear sntp client