Set Spantree Bridgeprioritymode; Clear Spantree Bridgeprioritymode - Enterasys Matrix DFE-Gold Series Configuration Manual

set spantree bridgeprioritymode

Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the Spanning Tree bridge priority mode setting:
Matrix(rw)->show spantree bridgeprioritymode
Bridge Priority Mode is set to IEEE802.1t mode.
set spantree bridgeprioritymode
Use this command to set the Spanning Tree bridge priority mode to 802.1D (legacy) or 802.1t. This
will affect the range of priority values used to determine which device is selected as the Spanning
Tree root as described in set spantree priority ("set spantree priority" on page 6‐20).
Syntax
set spantree bridgeprioritymode {8021d | 8021t}
Parameters
8021d
8021t
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the bridge priority mode to 802.1D:
Matrix(rw)->set spantree bridgeprioritymode 8021d

clear spantree bridgeprioritymode

Use this command to reset the Spanning Tree bridge priority mode to the default setting of 802.1t.
Syntax
clear spantree bridgeprioritymode
Parameters
None.
Sets the bridge priority mode to use 802.1D (legacy) values of values,
which are 0 ‐ 65535.
Sets the bridge priority mode to use 802.1t values, which are 0 ‐ 61440,
in increments of 4096. Values will be rounded up or down, depending
on the 802.1t value to which the entered value is closest.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-19
Configuring Spanning Tree Bridge Parameters