Preempt-Delay - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring VRRP
Defaults
None.
Mode
Router command, Router configuration: Matrix>Router(config‐router)#
Usage
The router that owns the virtual router IP address always preempts other routers, regardless of
this setting.
Preempt is enabled on VRRP routers by default, which allows a higher priority backup router to
preempt a lower priority master.
The "no" form of this command disables preempt mode.
Example
This example shows how to disable preempt mode on VLAN 1, VRID 1:
Matrix>Router(config)#router vrrp
Matrix>Router(config-router)#no preempt vlan 1 1

preempt-delay

Use this command to set a preempt delay time on a VRRP router.
Syntax
preempt-delay vlan-id vrid delay-timer
no preempt-delay vlan-id vrid
Parameters
vlan vlan‐id
vrid
delay‐timer
Defaults
None.
Mode
Router command, Router configuration: Matrix>Router(config‐router)#
Usage
The router that owns the virtual router IP address always preempts other routers, regardless of
this setting.
21-68 Routing Protocol Configuration
Specifies the number of the VLAN on which to set a preempt delay
value. This VLAN must be configured for IP routing as described in
"Reviewing and Configuring Routing" on page 2‐101, and must have
preempt mode enabled as described in "preempt" on page 21‐67.
Specifies a unique Virtual Router ID (VRID) associated with the routing
interface. Valid values are from 1 to 255.
Specifies a preempt delay time in seconds. Valid values are from 1 to
900.
preempt-delay