For information about...
show console
set console baud
show ip address
Use this command to display the system IP address and subnet mask.
Syntax
show ip address
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the system IP address and subnet mask:
B3(su)->show ip address
Name
----------------
host
set ip address
Use this command to set the system IP address, subnet mask and default gateway.
Syntax
set ip address ip-address [mask ip-mask] [gateway ip-gateway]
Parameters
ip‐address
mask ip‐mask
gateway ip‐gateway
Defaults
If not specified, ip‐mask will be set to the natural mask of the ip‐address and ip‐gateway will be set to
the ip‐address.
Address
----------------
10.42.13.20
Sets the IP address for the system. For SecureStack B3 systems, this is the
IP address of the management switch as described in "About SecureStack
B3 Switch Operation in a Stack" on page 2‐1.
(Optional) Sets the system's subnet mask.
(Optional) Sets the system's default gateway (next‐hop device).
Refer to page...
3-25
3-26
Mask
----------------
255.255.0.0
SecureStack B3 Configuration Guide 3-9
show ip address