Set Logging Default - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring System Logging
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This command shows how to display the Syslog server default values. For an explanation of the
command output, refer back to Table
Matrix(rw)->show logging default.
Defaults:

set logging default

Use this command to set logging default values.
Syntax
set logging default {[facility facility] [severity severity] port port]}
Parameters
facility facility
severity severity
port port
Defaults
None.
Mode
Switch command, Read‐Write.
10-6 System Logging Configuration
Facility Severity
-----------------------------------------
local4 warning(5)
Specifies the default facility name. Valid values are: local0 to local7.
Specifies the default logging severity level. Valid values and
corresponding levels are:
1 - emergencies (system is unusable)
2 - alerts (immediate action required)
3 - critical conditions
4 - error conditions
5 - warning conditions
6 - notifications (significant conditions)
7 - informational messages
8 - debugging messages
Specifies the default UDP port the client uses to send to the server.
10‐1.
Port
514
set logging default