Set Inlinepower Psetrap; Clear Inlinepower Psetrap - Enterasys Matrix DFE-Gold Series Configuration Manual

set inlinepower psetrap

Example
This example shows how to reset the PoE management mode to "realtime" on module 1:
Matrix(rw)->clear inlinepower management 1
set inlinepower psetrap
Use this command to enable or disable the sending of an SNMP trap message for a module
whenever the status of its ports changes, or whenever the module's PoE usage threshold is
crossed.
Syntax
set inlinepower psetrap {disable | enable} module-number
Parameters
disable | enable
module‐number
Defaults
Disabled.
Mode
Switch command, Read‐Write.
Usage
The module's PoE usage threshold must be set using the set inlinepower threshold command as
described in "set inlinepower threshold" on page 2‐67.
Example
This example shows how to enable PoE trap messaging on module 1:
Matrix(rw)->set inlinepower psetrap enable 1

clear inlinepower psetrap

Use this command to reset PoE trap messaging for a module back to default state of disabled.
Syntax
clear inlinepower psetrap module-number
Parameters
module‐number
Defaults
None.
Disables or enables PoE trap messaging.
Specifies the module on which to disable or enable trap messaging.
Specifies the module on which to clear PoE trap messaging.
Enterasys Matrix DFE-Gold Series Configuration Guide 2-69
Configuring Power over Ethernet (PoE)