Clear Maclock Static; Set Maclock Trap - Enterasys Matrix DFE-Gold Series Configuration Manual

clear maclock static

Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to restrict MAC locking to 4 static addresses on fe.2.3:
Matrix(rw)->set maclock static fe.2.3 4
clear maclock static
Use this command to reset the number of static MAC addresses allowed per port to the default
value of 20.
Syntax
clear maclock static port_string
Parameters
port_string
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset static MAC locking on fe.2.3:
Matrix(rw)->clear maclock static fe.2.3

set maclock trap

Use this command to enable or disable MAC lock trap messaging.
Syntax
set maclock trap port_string {enable | disable}
Parameters
port_string
enable | disable
Specifies the port on which to reset the static MAC locking limit. For a
detailed description of possible port_string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Specifies the port on which MAC lock trap messaging will be enabled
or disabled. For a detailed description of possible port_string values,
refer to "Port String Syntax Used in the CLI" on page 4‐2.
Enables or disables MAC lock trap messaging.
Enterasys Matrix DFE-Gold Series Configuration Guide 24-9
Configuring MAC Locking