Show Igmp Static; Set Igmp Add-Static - Enterasys Matrix DFE-Gold Series Configuration Manual

show igmp static

Example
This example shows how to display IGMP group information for VLAN 105. In this example, the
device knows to forward all multicast traffic for IP group address 224.0.0.2 (VLAN 105) to Fast
Ethernet port 2 in module 2, and 1‐Gigabit Ethernet port 14 in module 3:
Matrix(rw)->show igmp groups 105
-----------------------------------------------------------
Vlan Id
IGMP Port List = fe.2.2 ge.3.14
show igmp static
Use this command to display static IGMP ports for one or more VLANs or IGMP groups.
Syntax
show igmp static vlan-list [group group]
Parameters
vlan‐list
group group
Defaults
If not specified, static IGMP information will be displayed for all groups.
Mode
Switch command, Read‐Only.
Example
This example shows how to display static IGMP information for VLAN 105. The display is similar
to the show igmp groups display:
Matrix(rw)->show igmp static 105
-----------------------------------------------------------
Vlan Id
IGMP Port List = fe.2.2 ge.3.14

set igmp add-static

Use this command to create a new static IGMP entry, or to add one or more new ports to an
existing entry.
Syntax
set igmp add-static group vlan-list [modify] [include-ports] [exclude-ports]
Parameters
group
vlan‐list
= 105 Multicast Group Address = 224.0.0.2
Specifies the VLAN(s) for which to display static IGMP information.
(Optional) Displays information for a specific IGMP group (IP address).
= 105 Multicast Group Address = 224.0.0.2
Specifies a group IP address for the entry.
Specifies the VLAN(s) on which to configure the entry.
Enterasys Matrix DFE-Gold Series Configuration Guide 9-11
Configuring IGMP
Type = IGMP
Type = IGMP