Set Cep Port; Set Cep Policy - Enterasys Matrix DFE-Gold Series Configuration Manual

set cep port

Defaults
Disabled.
Mode
Switch command, Read‐Write.
Example
This example shows how to globally enable CEP detection:
Matrix>set cep enable
set cep port
Use this command to enable or disable a CEP detection type on one or more ports.
Syntax
set cep port port-string {cisco | h323 | lldp-med | siemens | sip} {enable |
disable}
Parameters
port‐string
cisco
h323
lldp‐med
siemens
sip
enable | disable
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to enable Cisco phone detection on port fe. 3. 1:
Matrix>set cep port fe.3.1 cisco enable

set cep policy

Use this command to set a global default policy for a CEP detection type.
Syntax
set cep policy {cisco | h323 | siemens | sip} index
Configuring Convergence End Points (CEP) Phone Detection
Specifies the port(s) to enable or disable. For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the CLI"
on page 4‐2.
Set the Cisco detection status on the specified ports.
Set the H323 detection status on the specified ports.
Set the LLDP‐MED detection status on the specified ports.
Set the Siemens detection status on the specified ports.
Set the SIP detection status on the specified ports.
Enables or disables CEP detection as specified.
Enterasys Matrix DFE-Gold Series Configuration Guide 25-43