Set Ciscodp Timer; Set Ciscodp Holdtime - Enterasys Matrix DFE-Gold Series Configuration Manual

set ciscodp timer

set ciscodp timer
Use this command to set the number of seconds between Cisco Discovery Protocol PDU
transmissions.
Syntax
set ciscodp timer time
Parameters
time
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the Cisco Discovery Protocol timer to 120 seconds:
Matrix>set ciscodp timer 120

set ciscodp holdtime

Use this command to set the time to live (TTL) for Cisco Discovery Protocol PDUs. This is the
amount of time (in seconds) neighboring devices will hold PDU transmissions from the sending
device.
Syntax
set ciscodp holdtime time
Parameters
time
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the Cisco Discovery Protocol hold time to 180 seconds:
Matrix>set ciscodp holdtime 180
Specifies the number of seconds between CiscoDP PDU transmissions.
Valid values are 5 ‐ 254.
Specifies the time to live for CiscoDP PDUs. Valid values are 10 ‐ 255.
Enterasys Matrix DFE-Gold Series Configuration Guide 3-11
Cisco Discovery Protocol