Show Multiauth Idle-Timeout; Set Multiauth Idle-Timeout - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Multiple Authentication
Termination time: Not Terminated

show multiauth idle-timeout

Use this command to display the multiple authentication timeout value for an idle session.
Syntax
show multiauth idle-timeout
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Usage
This will display the idle‐timeout values, in seconds, for the following authentication types: dot1x,
pwa, mac, and cep.
Example
This example shows how to display timeout values for an idle session, for each of the
authentication types:
Matrix(rw)->show multiauth idle-timeout
Authentication type
------------------- -------------
dot1x
pwa
mac
cep

set multiauth idle-timeout

Use this command to set the multiauth idle‐timeout value per authentication method or for all
methods.
Syntax
set multiauth idle-timeout [cep | dot1x | mac | pwa] timeout
Parameters
cep
dot1x
27-10 MultiAuth Configuration
Timeout (sec)
300
300
300
300
(Optional) Specifies the authentication type Enterasys Convergence
End Point Authentication.
(Optional) Specifies the authentication type IEEE 802.1X Port‐Based
Network Access Control.
show multiauth idle-timeout