Set Arp; Clear Arp; Show Arp Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

set arp

Table 12-1 show arp Output Details
Output...
IP Address
Phys Address
Flags
set arp
Use this command to add mapping entries to the switch's ARP table.
Syntax
set arp ip-address mac-address [{temp | pub | trail}]
Parameters
ip‐address
mac‐address
temp
pub
trail
Defaults
• If temp is not specified, the ARP entry will be added as a permanent entry.
• If pub is not specified, then the ARP entry will not be published.
• If trail is not specified, then trailer encapsulations will not be sent to the host.
Mode
Switch command, Read‐Write.
Example
This example shows how to map IP address 198.133.219.232 to MAC address 00‐00‐0c‐40‐0f‐bc:
Matrix(rw)->set arp 198.133.219.232 00-00-0c-40-0f-bc

clear arp

Use this command to delete a specific entry or all entries from the switch's ARP table.
Syntax
clear arp {ip | all}
What it displays...
IP address mapped to MAC address.
MAC address mapped to IP address.
Route status. Possible values and their definitions include:
S - manually configured entry (static)
P - respond to ARP requests for this entry
Specifies the IP address to map to the MAC address and add to the ARP
table.
Specifies the MAC address to map to the IP address and add to the ARP
table.
(Optional) Sets the ARP entry as not permanent. This allows the entry
to time out.
(Optional) Publishes the specified ARP entry. This causes the system to
respond to ARP requests for this entry, even though it is not the host.
(Optional) Specifies that trailer encapsulations can be sent to this host.
Enterasys Matrix DFE-Gold Series Configuration Guide 12-3
Managing Switch Network Addresses and Routes