Default Device Settings For Router Mode Operation - Enterasys Matrix DFE-Gold Series Configuration Manual

Table 2-1 Default Device Settings for Basic Switch Operation (continued)
Device Feature
VLAN ID
WebView (HTTP)
Table 2-2 Default Device Settings for Router Mode Operation
Device Feature
Access groups (IP security) None configured.
Access lists (IP security)
Area authentication
(OSPF)
Area default cost (OSPF)
Area NSSA (OSPF)
Area range (OSPF)
ARP table
ARP timeout
Authentication key (RIP
and OSPF)
Authentication mode (RIP
and OSPF)
Dead interval (OSPF)
Disable triggered updates
(RIP)
Distribute list (RIP)
DoS prevention
DVMRP
Hello interval (OSPF)
ICMP
IP-directed broadcasts
IP forward-protocol
IP interfaces
IRDP
MD5 authentication
(OSPF)
MTU size
OSPF
OSPF cost
OSPF network
Default Setting
All ports use a VLAN identifier of 1.
Enabled on TCP port 80.
Default Setting
None configured.
Disabled.
Set to 1.
None configured.
None configured.
No permanent entries configured.
Set to 14,400 seconds.
None configured.
None configured.
Set to 40 seconds.
Triggered updates allowed.
No filters applied.
Disabled.
Disabled. Metric set to 1.
Set to 10 seconds for broadcast and point-to-point networks. Set to 30
seconds for non-broadcast and point-to-multipoint networks.
Enabled for echo-reply and mask-reply modes.
Disabled.
Enabled with no port specified.
Disabled with no IP addresses specified.
Disabled on all interfaces. When enabled, maximum advertisement interval is
set to 600 seconds, minimum advertisement interval is set to 450 seconds,
holdtime is set to 1800 seconds, and address preference is set to 0.
Disabled with no password set.
Set to 1500 bytes on all interfaces.
Disabled.
Set to 10 for all interfaces.
None configured.
Enterasys Matrix DFE-Gold Series Configuration Guide 2-5
Startup and General Configuration Summary