Show Telnet; Starting And Configuring Telnet; Purpose; Commands - Enterasys Matrix DFE-Gold Series Configuration Manual

Starting and Configuring Telnet

Starting and Configuring Telnet

Purpose

To enable or disable Telnet, and to start a Telnet session to a remote host. The Matrix Series device
allows a total of four inbound and / or outbound Telnet session to run simultaneously.

Commands

The commands used to enable, start and configure Telnet are listed below and described in the
associated section as shown.
For information about...

show telnet

set telnet
telnet
show router telnet
set router telnet
clear router telnet
show telnet
Use this command to display the status of Telnet on the device.
Syntax
show telnet
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display Telnet:
Matrix(rw)->show telnet
Telnet inbound is currently: ENABLED
Telnet outbound is currently: ENABLED
2-76 Startup and General Configuration
status
show telnet
Refer to page...
2-76
2-77
2-77
2-78
2-78
2-79