Commands; Purpose; Disabling / Enabling And Naming Ports; Set Port Disable - Enterasys Matrix DFE-Gold Series Configuration Manual

Disabling / Enabling and Naming Ports

Disabling / Enabling and Naming Ports

Purpose

To disable and re‐enable one or more ports, and to assign an alias to a port. By default, all ports are
enabled at device startup. You may want to disable ports for security or to troubleshoot network
issues.

Commands

For information about...

set port disable

set port enable
show port alias
set port alias
show forcelinkdown
set forcelinkdown
clear forcelinkdown
set port disable
Use this command to administratively disable one or more ports.
Syntax
set port disable port-string
Parameters
port-string
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to disable Fast Ethernet port 1 in module1:
Matrix(rw)->set port disable fe.1.1
4-20 Port Configuration
Specifies the port(s) to disable. For a detailed description of possible
port‐string values, refer to "Port String Syntax Used in the CLI" on
page 4‐2.
set port disable
Refer to page...
4-20
4-21
4-21
4-22
4-22
4-23
4-23