show port flowcontrol
Setting Flow Control
Purpose
To review, enable or disable port flow control. Flow control is used to manage the transmission
between two devices as specified by IEEE 802.3x to prevent receiving ports from being
overwhelmed by frames from transmitting devices.
Commands
For information about...
show port flowcontrol
set port flowcontrol
show port flowcontrol
Use this command to display the flow control state for one or more ports.
Syntax
show port flowcontrol [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, flow control information for all ports will be displayed.
Mode
Read‐Only.
Example
This example shows how to display the port flow control state for fe.1.1‐5:
Matrix(rw)->show port flowcontrol fe.1.1-5
Port
------------ -------- -------- -------- -------- -------------- --------------
fe.1.1
fe.1.2
fe.1.3
fe.1.4
fe.1.5
(Optional) Displays flow control state for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
TX Admin
TX Oper RX Admin
enabled disabled
enabled disabled
enabled disabled
enabled disabled
enabled
enabled
enabled
enabled disabled
enabled disabled
enabled disabled
enabled disabled
RX Oper TX Pause Count RX Pause Count
enabled
Enterasys Matrix DFE-Gold Series Configuration Guide 4-37
Setting Flow Control
Refer to page...
4-37
4-38
0
0
0
0
0
0
0
0
0
0