Set Tacacs Session - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring TACACS+
Matrix(ro)->show tacacs session authorization
TACACS+ service:
TACACS+ session authorization A-V pairs:
This example shows how to display client session accounting state.
Matrix(ro)->show tacacs session accounting state
TACACS+ session accounting state:

set tacacs session

Use this command to enable or disable TACACS+ session accounting, or to configure TACACS+
session authorization parameters. For simplicity, separate syntax formats are shown for
configuring session accounting and session authorization.
Syntax
set tacacs session accounting {enable | disable}
set tacacs session authorization {
attribute value |
Parameters
accounting
enable | disable
authorization
service name
read‐only attribute
value
read‐write attribute
value
super‐user attribute
value
Defaults
None.
25-68 Authentication Configuration
access level attribute
read-only 'priv-lvl'
read-write 'priv-lvl'
super-user 'priv-lvl'
service
super-user attribute value}
Specifies that TACACS+ session accounting is being configured.
Enables or disables TACACS+ session accounting.
Specifies that TACACS+ session authorization is being configured.
Specifies the name of the service that the TACACS+ client will request
from the TACACS+ server. The name specified here must match the
name of a service configured on the server.
Specifies that the Matrix read‐only access privilege level should be
matched to a privilege level configured on the TACACS+ server by
means of an attribute‐value pair specified by attribute and value.
By default, attribute is "priv‐lvl" and value is 0.
Specifies that the Matrix read‐write access privilege level should be
matched to a privilege level configured on the TACACS+ server by
means of an attribute‐value pair specified by attribute and value.
By default, attribute is "priv‐lvl" and value is 1.
Specifies that the Matrix super‐user access privilege level should be
matched to a privilege level configured on the TACACS+ server by
means of an attribute‐value pair specified by attribute and value.
By default, attribute is "priv‐lvl" and value is 15.
exec
enabled
name | read-only attribute value |
set tacacs session
value
'0'
'1'
'15'
read-write