Show Spantree Adminpoint; Show Spantree Operpoint - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Port Parameters
Mode
Switch command, Read‐Only.
Example
This example shows how to display the edge port status for fe.2.7:
Matrix(rw)->show spantree operedge port fe.2.7
Port fe.2.7 has a Port Oper Edge of Edge-Port

show spantree adminpoint

Use this command to display the administrative point‐to‐point status of the LAN segment
attached to a Spanning Tree port.
Syntax
show spantree adminpoint [port port-string]
Parameters
port port‐string
Defaults
If port‐string is not specified, status will be displayed for all Spanning Tree port(s).
Mode
Switch command, Read‐Only.
Example
This example shows how to display the point‐to‐point status of the LAN segment attached to
fe.2.7:
Matrix(rw)->show spantree adminpoint port fe.2.7
Port fe.2.7 has a Port Admin Point to Point of Auto

show spantree operpoint

Use this command to display the operating point‐to‐point status of the LAN segment attached to a
port.
Syntax
show spantree operpoint [port port-string]
Parameters
port port‐string
6-62 Spanning Tree Configuration
(Optional) Displays point‐to‐point status for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
(Optional) Displays point‐to‐point operating status for specific port(s).
For a detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 4‐2.
show spantree adminpoint