Set Lldp Port Status - Enterasys Matrix DFE-Gold Series Configuration Manual

Link Layer Discovery Protocol and LLDP-MED
Mode
Switch command, Read‐Write.
Usage
When an LLDP‐MED endpoint device has connected to a port, the network connectivity device
starts sending LLDP‐MED TLVs at a fast start rate on that port. Use this command to set the
number of successive LLDPDUs (with LLDP‐MED TLVs) to be sent for one complete fast start
interval.
Example
This example sets the number of fast start LLDPDUs to be sent to 4.
Matrix(rw)->set lldp med-fast-repeat 4

set lldp port status

Use this command to enable or disable transmitting and processing received LLDPDUs on a port
or range of ports.
Syntax
set lldp port status {tx-enable | rx-enable | both | disable} port-string
Parameters
tx‐enable
rx‐enable
both
disable
port‐string
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example enables both transmitting LLDPDUs and receiving and processing LLDPDUs from
remote systems on ports ge.1.1 through ge.1.6.
Matrix(rw)->set lldp port status both ge.1.1-6
3-28 Discovery Protocols Configuration
Enables transmitting LLDPDUs on the specified ports.
Enables receiving and processing LLDPDUs from remote systems on
the specified ports.
Enables both transmitting and processing received LLDPDUs on the
specified ports.
Disables both transmitting and processing received LLDPDUs on the
specified ports.
Specifies the port or range of ports to be affected.
set lldp port status