Match Ip Address - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Policy-Based Routing
Defaults
• If permit or deny is not specified, this command will enable route map or policy based
routing configuration mode.
• If sequence‐number is not specified, 10 will be applied.
Mode
Router command, Global configuration: Matrix>Router(config)#
Usage
Use this command to add a route map to an existing route map list by specifying the list's id‐
number and a new sequence‐number.
The "no" form of this command removes the specified route map list:.
Example
This example shows how to create route map 101 with a sequence order of 20:
Matrix>Router(config)#route-map 101 permit 20

match ip address

Use this command to match a packet source IP address against a PBR access list. Up to 5 access
lists can be matched.
Syntax
match ip address access-list-number
no match ip address access-list-number
Parameters
ip address
access‐list‐number
Defaults
None.
Mode
Policy‐based routing configuration: Matrix>Router(config‐route‐map‐pbr)#
Usage
The "no" form of this command removes the match between an access list and this route map.
Example
This example shows how to match a packet source IP address to access list 1:
Matrix>Router(config)#route-map 101 Matrix>Router(config-route-map-pbr)#match ip
address 1
8-44 Policy Classification Configuration
Matches packet source IP addresses to the specified access list.
Specifies an access list to match to the packet source IP address. Valid
values are 1 ‐ 199.
match ip address