Set Spantree Spanguardtimeout; Clear Spantree Spanguardtimeout - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Bridge Parameters

set spantree spanguardtimeout

Use this command to set the amount of time (in seconds) an edge port will remain locked by the
span guard function.
Syntax
set spantree spanguardtimeout timeout
Parameters
timeout
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the span guard timeout to 600 seconds:
Matrix(rw)->set spantree spanguardtimeout 600

clear spantree spanguardtimeout

Use this command to reset the Spanning Tree span guard timeout to the default value of 300
seconds.
Syntax
clear spantree spanguardtimeout
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the span guard timeout to 300 seconds:
Matrix(rw)->clear spantree spanguardtimeout
6-38 Spanning Tree Configuration
Specifies a timeout value in seconds. Valid values are 0 (forever) to
65535.
set spantree spanguardtimeout