Show Spantree Fwddelay; Set Spantree Fwddelay - Enterasys Matrix DFE-Gold Series Configuration Manual

show spantree fwddelay

Example
This example shows how to globally reset the maximum aging time:
Matrix(rw)->clear spantree maxage
show spantree fwddelay
Use this command to display the Spanning Tree forward delay time.
Syntax
show spantree fwddelay
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the Spanning Tree forward delay time:
Matrix(rw)->show spantree fwddelay
Bridge Forward Delay is set to 15 seconds

set spantree fwddelay

Use this command to set the Spanning Tree forward delay.
Syntax
set spantree fwddelay delay
Parameters
delay
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
Spanning Tree forward delay is the maximum time (in seconds) the root device will wait before
changing states (that is, listening to learning to forwarding). This delay is required because every
device must receive information about topology changes before it starts to forward frames. In
Specifies the number of seconds for the bridge forward delay. Valid
values are 4 ‐ 30.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-27
Configuring Spanning Tree Bridge Parameters