Enterasys Matrix DFE-Gold Series Configuration Manual page 559

show nodealias mac
Parameters
mac_address
ip | apl | mac | hsrp |
dhcps | dhcpc |
bootps | bootpc |
ospf | vrrp | ipx |
xrip | xsap | ipx20 |
rtmp | netBios | nbt |
bgp | rip | igrp | dec
| bpdu | udp
port‐string
Defaults
• If protocol is not specified, node alias entries for all protocols will be displayed.
• If port‐string is not specified, node alias entries will be displayed for all ports.
Mode
Switch command, Read‐Only.
Specifies a MAC address for which to display node alias entries. This
can be a full or partial address.
(Optional) Displays node alias entries for one of the following
protocols:
• Internet Protocol
• Appletalk
• Media Access Control
• Hot Standby Routing Protocol
• Dynamic Host Control Protocol Server
• Dynamic Host Control Protocol Client
• Boot Protocol Server
• Boot Protocol Client
• Open Shortest Path First
• Virtual Router Redundancy Protocol
• Internet Packet Exchange
• IPX Routing Information Protocol
• IPX Service Access Point
• PX Protocol 20 packet
• Routing Table Maintenance Protocol
• NetBIOS (raw)
• NetBIOS (over TCP/IP)
• Border Gateway Protocol
• Routing Information Protocol
• Interior Gateway Routing Protocol
• Digital Equipment Corporation
• Bridge Protocol Data Unit
• User Datagram Protocol
(Optional) Displays node alias properties for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Enterasys Matrix DFE-Gold Series Configuration Guide 14-3
Configuring Node Aliases