Set Spantree Adminpoint - Enterasys Matrix DFE-Gold Series Configuration Manual

set spantree adminpoint

Defaults
If not specified, status will be displayed for all ports.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the point‐to‐point status operating of the LAN segment
attached to fe.2.7:
Matrix(rw)->show spantree operpoint port fe.2.7
Port fe.2.7 has a Port Oper Point to Point of False on SID 1
set spantree adminpoint
Use this command to set the administrative point‐to‐point status of the LAN segment attached to
a Spanning Tree port.
Syntax
set spantree adminpoint port-string {true | false | auto}
Parameters
port‐string
true | false | auto
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the LAN attached to fe.1.3 as a point‐to‐point segment:
Matrix(rw)->set spantree adminpoint fe.1.3 true
Specifies the port on which to set point‐to‐point protocol status. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Specifies the point‐to‐point status of the LAN attached to the specified
port.
• true forces the port to be considered point‐to‐point.
• false forces the port to be considered non point‐to‐point.
• auto (the default setting) allows the firmware to determine the
port's point‐to‐point status.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-63
Configuring Spanning Tree Port Parameters