Set Snmp Notify; Clear Snmp Notify - Enterasys Matrix DFE-Gold Series Configuration Manual

set snmp notify

set snmp notify
Use this command to set the SNMP notify configuration.
Syntax
set snmp notify notify tag tag [trap | inform] [volatile | nonvolatile]
Parameters
notify
tag tag
trap | inform
volatile | nonvolatile (Optional) Specifies temporary (default), or permanent storage for
Defaults
• If not specified, message type will be set to trap.
• If not specified, storage type will be set to nonvolatile.
Mode
Switch command, Read‐Write.
Usage
This creates an entry in the SNMP notify table, which is used to select management targets who
should receive notification messages. This command's tag parameter can be used to bind each
entry to a target address using the set snmp targetaddr command ("set snmp targetaddr" on
page 5‐30).
Example
This example shows how to set an SNMP notify configuration with a notify name of "hello" and a
notify tag of "world". Notifications will be sent as trap messages and storage type will
automatically default to permanent:
Matrix(rw)->set snmp notify hello tag world trap

clear snmp notify

Use this command to clear an SNMP notify configuration.
Syntax
clear snmp notify notify
Parameters
notify
Specifies an SNMP notify name.
Specifies an SNMP notify tag. This binds the notify name to the SNMP
target address table.
(Optional) Specifies SNMPv1 or v2 Trap messages (default) or SNMP v3
InformRequest messages.
SNMP entries.
Specifies an SNMP notify name to clear.
Enterasys Matrix DFE-Gold Series Configuration Guide 5-35
Configuring SNMP Notification Parameters