Show Cos Port-Type - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Policy Class of Service (CoS)

show cos port-type

Use this command to display Class of Service port type configurations.
Syntax
show cos port-type [irl | txq] [index-list]
Parameters
irl | txq
index‐list
Defaults
If not specified, all rate limiting information for all port types will be displayed.
Mode
Switch command, Read‐Only.
Usage
The Enterasys Matrix Series CoS implementation provides two default port type groupings for
designating available rate limiting and transmit queue resources on device modules. Port type 0
designates one of 7GR4270‐12, 7G4270‐12, 7G4270‐09, or 7G4270‐10 DFE modules. Port type 1
designates all other modules, including DFE‐Gold and NSA modules. Other port groupings can
be configured using the commands in this section.
Example
This example shows how to display all Class of Service port type information. In this case, no new
port groups have been configured, so information for the two device default groups of 0 and 1 are
shown:
Matrix(rw)->show cos port-type
Number of resources:
txq = transmit queue(s)
irl = inbound rate limiter(s)
orl = outbound rate limiter(s)
Index
-----
0
8-24 Policy Classification Configuration
(Optional) Displays inbound rate limiting or transmit queue
information.
(Optional) Displays information for a specific port type.
Number of
slices /
Port type Number of
description queues
------------ ---------
DFE-P 16Q 64/16
Supported rate types:
perc = percentage
pps = packets per second
Kbps = kilobits per second
Mbps = megabits per second
Gbps = gigabits per second
Tbps = terabits per second
Supported Eligible
rate type ports
--------- -----------------
perc ge.1.1-12
Kbps
Mbps
show cos port-type
Unselected
ports
--------------
ge.1.1-12