Show Igmp Config; Show Igmp Config Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring IGMP
Mode
Switch command, Read‐Write.
Example
This example shows how to flood multicast frames to the VLAN when the multicast group table is
full:
Matrix(rw)->set igmp grp-full-action 2

show igmp config

Use this command to display IGMP configuration information for one or more VLANs.
Syntax
show igmp config vlan-list
Parameters
vlan‐list
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display IGMP configuration information for VLAN 1:
Matrix(rw)->show igmp config 1
IGMP config for vlan 1
VlanQueryInterval
VlanStatus
Vlan IGMP Version
VlanQuerier
VlanQueryMaxResponseTime
VlanRobustness
VlanLastMemberQueryIntvl
VlanQuerierUpTime
Table 9‐1 shows a detailed explanation of command output. For details on using the set igmp
config command to set these parameters, refer to "set igmp config" on page 9‐9.
Table 9-1 show igmp config Output Details
Output...
VlanQueryInterval
VlanStatus
9-8 IGMP Configuration
Specifies the VLAN(s) for which to display IGMP configuration
information.
- 125
- Active
- 2
- 134.141.22.1
- 10
- 2
- 10
- 24039
What it displays...
Frequency (in seconds) of host-query frame transmissions.
Whether or not VLAN configuration is Active or Not in Service.
show igmp config