Clear Cdp - Enterasys Matrix DFE-Gold Series Configuration Manual

clear cdp

Example
This example shows how to set CDP hold time to 60 seconds:
Matrix(rw)->set cdp hold-time 60
clear cdp
Use this command to reset CDP discovery protocol settings to defaults.
Syntax
clear cdp {[state] [port-state port-string] [interval] [hold-time] [auth-code]}
Parameters
state
port‐state port‐string
interval
hold‐time
auth‐code
Defaults
At least one optional parameter must be entered.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the CDP state to auto‐enabled:
Matrix(rw)->clear cdp state
(Optional) Resets the global CDP state to auto‐enabled.
(Optional) Resets the port state on specific port(s) to auto‐enabled.
(Optional) Resets the message frequency interval to 60 seconds.
(Optional) Resets the hold time value to 180 seconds.
(Optional) Resets the authentication code to 16 bytes of 00 (00‐00‐00‐00‐
00‐00‐00‐00).
Enterasys Matrix DFE-Gold Series Configuration Guide 3-7
Enterasys Discovery Protocol