Reset - Enterasys Matrix DFE-Gold Series Configuration Manual

reset

reset
Use this command to reset the device without losing any user‐defined configuration settings
Syntax
reset {[mod | system | nemcpu {mod.nemcpu}] [cancel]}
Parameters
mod
system
nemcpu
cancel
Defaults
None.
Mode
Read‐Write.
Usage
A Matrix Series device can also be reset with the RESET button located on its front panel. For
information on how to do this, refer to the Matrix Installation Guide shipped with your device.
Examples
This example shows how to reset the system.
Matrix(rw)->reset
This command will reset the system and may disconnect your telnet session.
Do you want to continue (y/n) [n]? y
Resetting...
This example shows how to cancel a scheduled system reset:
Matrix(rw)->reset cancel
Reset cancelled.
This example shows how to reset a Matrix Security Module installed on the DFE in slot 4.
Matrix(rw)->reset nemcpu 4.1
This command will reset NEM CPU 4.1.
Do you want to continue (y/n) [n]? y
Resetting NEM CPU 4.1 ...
Specifies a module to be reset.
Resets the system.
mod nemcpu
. Resets the CPU on a Matrix Security Module or other processing NEM,
mod
where
Module or processing NEM is installed and
location of the NEM. Currently, this value can only be 1.
Cancels a reset scheduled using the reset at command as described in
"reset at" on page
in" on page 2‐96.
specifies the DFE module in which the Matrix Security
2‐96, or the reset in command as described in "reset
Enterasys Matrix DFE-Gold Series Configuration Guide 2-95
Resetting the Device
nemcpu
specifies the