Chapter 2: Startup And General Configuration; Startup And General Configuration Summary; Default Device Settings For Basic Switch Operation - Enterasys Matrix DFE-Gold Series Configuration Manual

Startup and General Configuration Summary

Table 2-1 Default Device Settings for Basic Switch Operation
Device Feature
CDP discovery protocol
CDP authentication code
CDP hold time
CDP interval
Cisco Discovery Protocol
Community name
Convergence End Points
phone detection
EAPOL
EAPOL authentication
mode
GARP timer
GVRP
IGMP
IP mask and gateway
IP routes
Jumbo frame support
Link aggregation admin
key
Link aggregation flow
regeneration
Link aggregation system
priority
Link aggregation outport
algorithm
Link Layer Discovery
Protocol (LLDP)
LLDP transmit interval
LLDP hold multiplier
LLDP trap interval
LLDP-MED fast repeat
LLDP traps
LLDP-MED traps
Lockout
Logging
2-2 Startup and General Configuration
Default Setting
Auto enabled on all ports.
Set to 00-00-00-00-00-00-00-00
Set to 180 seconds.
Transmit frequency of CDP messages set to 60 seconds.
Globally auto-enabled, enabled on ports.
Public.
Disabled globally and on all ports
Disabled.
When enabled, set to auto for all ports.
Join timer set to 20 centiseconds; leave timer set to 60 centiseconds; leaveall
timer set to 1000 centiseconds.
Globally enabled.
Disabled. When enabled, query interval is set to 125seconds and response
time is set to 100 tenths of a second.
Subnet mask set to 255.0.0.0; default gateway set to 0.0.0.0
No static routes configured.
Disabled on all ports.
Set to 32768 for all ports.
Disabled.
Set to 32768 for all ports.
Set to DIP-SIP.
Both transmitting and receiving LLDPDUs are enabled.
30 seconds
4
5 seconds
3 fast start LLDPDUs
Disabled
Disabled
Set to disable Read-Write and Read-Only users, and to lockout the default
admin (Super User) account for 15 minutes, after 3 failed login attempts,
Syslog port set to UDP port number 514. Logging severity level set to 6
(significant conditions) for all applications.