Commands; Purpose; Managing Switch Network Addresses And Routes - Enterasys Matrix DFE-Gold Series Configuration Manual

Network Address and Route Management
This chapter describes switch‐related network address and route management commands and
how to use them.

Managing Switch Network Addresses and Routes

Purpose

To display, add or delete switch ARP table entries, to enable or disable RAD (Runtime Address
Discovery) protocol, to display, add or delete IP routing table addresses, and to display MAC
address information.

Commands

For information about...
show arp
set arp
clear arp
show rad
set rad
show ip route
traceroute
set ip route
clear ip route
show port mac
show mac
set mac
clear mac
Note: The commands in this section pertain to the Enterasys Matrix Series device from the switch
CLI only. For information on router-related network management tasks, including reviewing router
ARP tables and IP traffic, refer to Chapter 16.
Enterasys Matrix DFE-Gold Series Configuration Guide 12-1
12
Configuration
Refer to page...
12-2
12-3
12-3
12-4
12-4
12-5
12-6
12-8
12-8
12-9
12-10
12-11
12-12