Clear Sntp Server; Set Sntp Broadcastdelay - Enterasys Matrix DFE-Gold Series Configuration Manual

clear sntp server

Example
This example shows how to set the server at IP address 10.21.1.100 as an SNTP server:
Matrix(rw)->set sntp server 10.21.1.100
clear sntp server
Use this command to remove one or all servers from the SNTP server list.
Syntax
clear sntp server {ip-address | all}
Parameters
ip‐address
all
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to remove the server at IP address 10.21.1.100 from the SNTP server list:
Matrix(rw)->clear sntp server 10.21.1.100

set sntp broadcastdelay

Use this command to set the round trip delay, in microseconds, for SNTP broadcast frames.
Syntax
set sntp broadcastdelay time
Parameters
time
Defaults
None.
Mode
Switch command, Read‐Write.
Specifies the IP address of a server to remove from the SNTP server list.
Removes all servers from the SNTP server list.
Specifies broadcast delay time in microseconds. Valid values are 1 to
999999. Default value is 3000.
Enterasys Matrix DFE-Gold Series Configuration Guide 13-5
Configuring Simple Network Time Protocol (SNTP)