Clear Spantree Adminpoint - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Port Parameters

clear spantree adminpoint

Use this command to reset the administrative point‐to‐point status of the LAN segment attached
to a Spanning Tree port to auto mode.
Syntax
clear spantree adminpoint port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset point‐to‐point status to auto on fe.2.3:
Matrix(rw)->clear spantree adminpoint fe.2.3
6-64 Spanning Tree Configuration
Specifies port(s) on which to reset point‐to‐point protocol status. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
clear spantree adminpoint