Set Tacacs Singleconnect - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring TACACS+
Defaults
If state is not specified, all single connection configuration parameters are displayed (which at this
time includes only the enabled/disabled state).
Mode
Switch command, Read‐Write.
Example
This example shows how to display the state of the TACACS+ client's ability to send multiple
requests over a single connection.
Matrix(rw)->show tacacs singleconnect
TACACS+ single-connect state:

set tacacs singleconnect

Use this command to enable or disable the ability of the TACACS+ client to send multiple requests
over a single TCP connection. When enabled, the TACACS+ client will use a single TCP
connection for all requests to a given TACACS+ server.
Syntax
set tacacs singleconnect {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, Read‐Write.
Examples
This example shows how to disable sending multiple requests over a single connection.
Matrix(rw)->set tacacs singleconnect disable
25-72 Authentication Configuration
enabled
Enable or disable the ability to send multiple requests over a single TCP
connection.
set tacacs singleconnect