Clear Multiauth Trap - Enterasys Matrix DFE-Gold Series Configuration Manual

clear multiauth trap

Parameters
system
module
port portstring
all
success
failed
terminated
max‐reached
Defaults
All sending of multiauth traps disabled.
Mode
Switch command, Read‐Write.
Examples
This example shows how to enable the multiauth system trap setting:
Matrix(rw)->set multiauth trap system enabled
This example shows how to enable all multiauth port trap setting:
Matrix(rw)->set multiauth trap port ge.1.1 all
clear multiauth trap
Use this command to clear the system's multiple authentication trap settings.
Syntax
clear multiauth trap {system | module | port portstring {all | success | failed |
terminated | max-reached}}
Parameters
port portstring
all
success
failed
Configures multiauth system trap settings as follows:
enabled - traps are sent when max users reached in system
disabled - traps are not sent when max users reached in system
Configures multiauth module trap settings as follows:
enabled - traps are sent when max users reached in module
disabled - traps are not sent when max users reached in module
Configures multiauth port trap settings for the port specified in
portstring.
Enables sending all traps for the specified port.
Enables sending success traps for the specified port.
Enables sending failed traps for the specified port.
Enables sending terminated traps for the specified port.
Enables sending max number users reached traps for the specified port.
Clears the configuration of multiauth port trap settings for the port
specified in portstring.
Enables sending all traps for the specified port.
Enables sending success traps for the specified port.
Enables sending failed traps for the specified port.
Enterasys Matrix DFE-Gold Series Configuration Guide 27-15
Configuring Multiple Authentication