Clear Cep - Enterasys Matrix DFE-Gold Series Configuration Manual

clear cep

clear cep
Use this command to clear convergence end points parameters.
Syntax
clear cep {all | policy | detection [detection-id] | users [port-string] | port
[port-string {all | cisco | h323 | siemens |sip} ] }
Parameters
all
policy
detection [detection‐id] Restore factory defaults to CEP detection group configuration.
users [port‐string]
port [port‐string {all |
cisco | h323 | siemens
| sip }]
Defaults
If no detection‐id is specified, all CEP detection groups are returned to the default configuration.
If no port‐string is specified with the users parameter, all discovered Convergence Endpoints are
cleared.
If no port‐string is specified with the port parameter, all ports are cleared.
Mode
Switch command, Read‐Write.
Examples
This example shows how to clear all CEP policy parameters
Matrix>clear cep policy
This example shows how to clear detection id 4 parameters
Matrix>clear cep detection-id 4
This example shows how to clears ports fe.1.1‐5 of Cisco phone detection parameters
Matrix>clear cep port fe.1.1-5 cisco
Configuring Convergence End Points (CEP) Phone Detection
Restores factory defaults to all CEP configuration information.
Restore factory defaults to CEP policy configuration.
Optionally, specify a particular CEP configuration group to clear with
detection‐id. Valid values are 1 ‐ 2147483647.
Clear discovered Convergence Endpoints. Optionally, specify one or
more port(s) on which to clear discovered CEPs. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
Resets the CEP enabled state to the default of disabled. Optionally,
specify one or more port(s) to disable and specify all detection types or
individual detection types to disable. For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the CLI"
on page 4‐2.
Enterasys Matrix DFE-Gold Series Configuration Guide 25-49