Clear Flowlimit Limit; Set Flowlimit Action - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Flow Setup Throttling (FST)

clear flowlimit limit

Use this command to remove a flow limit configuration.
Syntax
clear flowlimit {limit1 | limit2} [userport | serverport | aggregateduser |
interswitchlink | unspecified]
Parameters
limit1 | limit2
userport | serverport
| aggregateduser |
interswitchlink |
unspecified
Defaults
If not specified, the limit will be removed from all port classification types.
Mode
Switch command, Read‐Write.
Example
This example shows how to remove flow limit 1 from all port classifications:
Matrix(rw)->clear flowlimit limit1

set flowlimit action

Use this command to associate an action with a flow limit. This is the action that will occur once
the associated flow limit is reached.
Syntax
set flowlimit {action1 | action2} [notify] [drop] [disable] [userport | serverport
| aggregateduser | interswitchlink | unspecified]
Parameters
action1 | action2
notify
24-28 Security Configuration
Specifies the configuration to be removed as limit 1 or 2.
(Optional) Removes this limit configuration from the user classification
port type:
• user port
• server port
• aggregation port
• inter‐switch link
• unspecified port
Specifies this configuration as action 1 or 2. Two actions describing
what will occur when a certain flow limit is reached can be defined per
user classification. Action number must correspond to a flow limit
configured using the set flowlimit limit command as described in "set
flowlimit limit" on page 24‐27.
(Optional) When flow limit is reached, generates an SNMP trap
notification (if the set flowlimit notification function is enabled as
described in "set flowlimit notification" on page 24‐33).
clear flowlimit limit