Show Port Counters - Enterasys Matrix DFE-Gold Series Configuration Manual

show port counters

Table 4-1 show port status Output Details
Output...
Oper Status
Admin Status
Speed
Duplex
Type
show port counters
Use this command to display port counter statistics detailing traffic through the device and
through all MIB2 network devices.
Syntax
show port counters [port-string] [switch | mib2]
Parameters
port‐string
switch | mib2
Defaults
• If port‐string is not specified, counter statistics will be displayed for all ports.
• If mib2 or switch are not specified, all counter statistics will be displayed for the specified
port(s).
Mode
Switch command, Read‐Only.
Examples
This example shows how to display all counter statistics, including MIB2 network traffic and
traffic through the device for fe.3.1:
Matrix(rw)->show port counters fe.3.1
Port: fe.3.1
What it displays...
Operating status (up or down).
Whether the specified port is enabled (up) or disabled (down). For
details on using the set port disable command to change the default
port status of enabled, refer to
details on using the set port enable command to re-enable ports, refer
to "set port
Operational speed in Mbps or Kbps of the specified port. For details on
using the set port speed command to change defaults, refer to
port speed" on page 4-25.
Duplex mode (half or full) of the specified port. For details on using the
set port duplex command to change defaults, refer to
Negotiation and Advertised
Physical port and interface type.
(Optional) Displays counter statistics for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
(Optional) Displays switch or MIB2 statistics. Switch statistics detail
performance of the Matrix switch device. MIB2 interface statistics detail
performance of all network devices.
MIB2 Interface: 1
"set port
enable" on page 4-21.
Ability" on page 4-30.
Bridge Port: 2
Enterasys Matrix DFE-Gold Series Configuration Guide 4-15
Reviewing Port Status
disable" on page 4-20. For
"set
"Setting Auto-