Ip Rip Offset - Enterasys Matrix DFE-Gold Series Configuration Manual

ip rip offset

Parameters
weight
Defaults
None.
Mode
Router command, Router configuration: Matrix>Router(config‐router)#
Usage
If several routes (coming from different protocols) are presented to the Enterasys Matrix Series
Route Table Manager (RTM), the protocol with the lowest administrative distance will be chosen
for route installation. By default, RIP administrative distance is set to 120. The distance command
can be used to change this value, resetting RIP's route preference in relation to other routes as
shown in the table below.
Route Source
Connected
Static
OSPF
RIP
The "no" form of this command resets RIP administrative distance to the default value of 120.
Example
This example shows how to change the default administrative distance for RIP to 1001:
Matrix>Router(config)#router rip
Matrix>Router(config-router)#distance 100
ip rip offset
Use this command to add or remove an offset to the metric of an incoming or outgoing RIP route.
Syntax
ip rip offset {in | out} value
no ip rip offset {in | out}
Parameters
in
out
value
Specifies an administrative distance for RIP routes. Valid values are 1 ‐
255.
Applies the offset to incoming metrics.
Applies the offset to outgoing metrics.
Specifies a positive offset to be applied to routes learned via RIP. Valid
values are from 0 to 16. If the value is 0, no action is taken.
Enterasys Matrix DFE-Gold Series Configuration Guide 21-5
Default Distance
0
1
110
120
Configuring RIP