Set Cep Detection-Id Type - Enterasys Matrix DFE-Gold Series Configuration Manual

set cep detection-id type

Usage
This command applies only to Siemens, H.323, and SIP phone detection. Cisco detection uses
CiscoDP as its discovery method.
Example
This example shows how to create CEP detection group 1:
Matrix>set cep detection-id 1 create
set cep detection-id type
Use this command to specify whether a phone detection group will use H.323, Siemens or SIP as
its phone discovery type.
Syntax
set cep detection-id id type {h323 | siemens | sip}
Parameters
id
h323 | siemens | sip
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
This command applies only to Siemens, H.323, and SIP phone detection. Cisco detection uses
CiscoDP as its discovery method.
There are currently 3 manual detection types (Siemens, H323, SIP). Under manual detection
configuration, for each of the types, the "Endpoint Phone Type" will be listed correctly. However,
the high and low ports will not reflect default ports for the "Endpoint Phone Types". The user will
have to configure the port low and high options to match their needs for the Endpoint Phone Type
being configured, as described in "set cep detection‐id porthigh | portlow" on page 25‐47.
Example
This example shows how to set the phone detection type to H.323 for CEP group 1:
Matrix>set cep detection-id 1 type h323
Configuring Convergence End Points (CEP) Phone Detection
Specifies a CEP configuration group ID. This group must be created
and enabled using the set cep detection‐id command as described in
"set cep detection‐id" on page 25‐44. Valid values are 1 ‐ 2147483647.
Specifies the phone type to detect as H.323,Siemens or SIP.
Enterasys Matrix DFE-Gold Series Configuration Guide 25-45