Clear Igmp Protocols; Show Igmp Vlan - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring IGMP
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to change IGMP routing protocols to a protocol id of 3:
Matrix(rw)->set igmp protocols classification 2 protocol-id 3 modify

clear igmp protocols

Use this command to clear the binding of IP protocol id to IGMP classification
Syntax
clear igmp protocols [protocol-id protocol-id]
Parameters
protocol‐id protocol‐id
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to clear IGMP protocols for protocol id 3:
Matrix(rw)->clear igmp protocols protocol-id 3

show igmp vlan

Use this command to display IGMP information for a specific VLAN.
Syntax
show igmp vlan [vlan-list]
Parameters
vlan‐list
Defaults
If vlan‐list is not displayed, information for all VLANs are displayed.
Mode
Switch command, Read‐Only.
9-14 IGMP Configuration
The protocol ids to change (0‐255).
(Optional) Show IGMP info for the given VLAN.
clear igmp protocols