Set Snmp Notifyfilter; Clear Snmp Notifyfilter - Enterasys Matrix DFE-Gold Series Configuration Manual

set snmp notifyfilter

set snmp notifyfilter
Use this command to create an SNMP notify filter configuration.
Syntax
set snmp notifyfilter profile subtree oid-or-mibobject [mask mask] [included |
excluded] [volatile | nonvolatile]
Parameters
profile
subtree oid‐or‐
mibobject
mask mask
included | excluded
volatile | nonvolatile (Optional) Specifies a storage type.
Defaults
• If not specified, mask is not set.
• If not specified, subtree will be included.
• If storage type is not specified, nonvolatile (permanent) will be applied.
Mode
Switch command, Read‐Write.
Usage
This identifies which management targets should NOT receive notification messages, which is
useful for fine‐tuning the amount of SNMP traffic generated.
Example
This example shows how to create an SNMP notify filter called "pilot1" with a MIB subtree ID of
1.3.6:
Matrix(rw)->set snmp notifyfilter pilot1 subtree 1.3.6

clear snmp notifyfilter

Use this command to delete an SNMP notify filter configuration.
Syntax
clear snmp notifyfilter profile subtree oid-or-mibobject
Parameters
profile
subtree oid‐or‐
mibobject
Specifies an SNMP filter notify name.
Specifies a MIB subtree ID target for the filter.
(Optional) Applies a subtree mask.
(Optional) Specifies that subtree is included or excluded.
Specifies an SNMP filter notify name to delete.
Specifies a MIB subtree ID containing the filter to be deleted.
Enterasys Matrix DFE-Gold Series Configuration Guide 5-37
Configuring SNMP Notification Parameters