Ip Dvmrp Metric; Show Ip Dvmrp Route - Enterasys Matrix DFE-Gold Series Configuration Manual

ip dvmrp metric

The "no" form of this command disables DVMRP.
Example
This example shows how to enable DVMRP on VLAN 1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip dvmrp
ip dvmrp metric
Use this command to configure the metric associated with a set of destinations for DVMRP
reports.
Syntax
ip dvmrp metric metric
Parameters
metric
Defaults
None.
Mode
Router command, Interface configuration: Matrix>Router(config‐if(Vlan 1))#
Usage
To reset the DVMRP metric back to the default value of 1, enter ip dvmrp metric 0.
Example
This example shows how to set a DVMRP of 16 on VLAN 1:
Matrix>Router(config-if(Vlan 1))#ip dvmrp metric 16

show ip dvmrp route

Use this command to display DVMRP routing information.
Syntax
show ip dvmrp route
Parameters
None.
Defaults
None.
Specifies a metric associated with a set of destinations for DVMRP
reports. Valid values are from 0 to 31. Entering a 0 value will reset the
metric back to the default value of 1.
Enterasys Matrix DFE-Gold Series Configuration Guide 21-53
Configuring DVMRP