Set Lldp Trap-Interval; Set Lldp Med-Fast-Repeat - Enterasys Matrix DFE-Gold Series Configuration Manual

set lldp trap-interval

Example
This example sets the transmit interval to 20 seconds and the hold multiplier to 5, which will
configure a time‐to‐live of 100 to be used in the TTL field in the LLDPDU header.
Matrix(rw)->set lldp tx-interval 20
Matrix(rw)->set lldp hold-multiplier 5
set lldp trap-interval
Use this command to set the minimum interval between LLDP notifications sent by this device.
LLDP notifications are sent when a remote system change has been detected.
Syntax
set lldp trap-interval frequency
Parameters
frequency
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example sets the minimum interval between LLDP traps to 10 seconds.
Matrix(rw)->set lldp trap-interval 10

set lldp med-fast-repeat

Network connectivity devices transmit only LLDP TLVs in LLDPDUs until they detect that an
LLDP‐MED endpoint device has connected to a port.
Syntax
set lldp med-fast-repeat count
Parameters
count
Defaults
None.
Specifies the minimum time between LLDP trap transmissions, in
seconds. The value can range from 5 to 3600 seconds. The default value
is 5 seconds.
Specifies the number of fast start LLDPDUs to be sent when an LLDP‐
MED endpoint device is detected. Value can range from 1 to 10. Default
is 3.
Enterasys Matrix DFE-Gold Series Configuration Guide 3-27
Link Layer Discovery Protocol and LLDP-MED