Set Snmp User; Clear Snmp User - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring SNMP Users, Groups and Communities

set snmp user

Use this command to create a new SNMPv3 user.
Syntax
set snmp user user [remote remoteid] [authentication {md5 | sha}] [authpassword]
[privacy privpassword] [volatile | nonvolatile]
Parameters
user
remote remoteid
authentication md5 |
sha
authpassword
privacy privpassword
volatile | nonvolatile (Optional) Specifies a storage type for this user entry.
Defaults
• If remote is not specified, the user will be registered for the local SNMP engine.
• If authentication is not specified, no authentication will be applied.
• If privacy is not specified, no encryption will be applied.
• If storage type is not specified, nonvolatile will be applied.
Mode
Switch command, Read‐Write.
Example
This example shows how to create a new SNMP user named "netops". By default, this user will be
registered on the local SNMP engine without authentication and encryption. Entries related to this
user will be stored in permanent (nonvolatile) memory:
Matrix(rw)->set snmp user netops

clear snmp user

Use this command to remove a user from the SNMPv3 security‐model list.
Syntax
clear snmp user user [remote remote]
Parameters
user
remote remote
5-12 SNMP Configuration
Specifies a name for the SNMPv3 user.
(Optional) Registers the user on a specific remote SNMP engine.
(Optional) Specifies the authentication type required for this user as
MD5 or SHA.
(Optional) Specifies a password for this user when authentication is
required. Minimum of 8 characters.
(Optional) Applies encryption and specifies an encryption password.
Minimum of 8 characters
Specifies an SNMPv3 user to remove.
(Optional) Removes the user from a specific remote SNMP engine.
set snmp user