Clear Port Vlan; Show Vlan Interface - Enterasys Matrix DFE-Gold Series Configuration Manual

clear port vlan

Example
This example shows how to add fe.1.10 to the port VLAN list of VLAN 4 (PVID 4). Since VLAN 4
is a new VLAN, it is created. Then port fe.1.10 is added to VLAN 4's untagged egress list, and is
cleared from the egress list of VLAN 1 (the default VLAN):
Matrix(rw)->set port vlan fe.1.10 4
Matrix(rw)->set vlan 4 create
Matrix(rw)->set vlan egress 4 fe.1.10 untagged
Matrix(rw)->clear vlan egress 1 fe.1.10
clear port vlan
Use this command to reset a port's 802.1Q port VLAN ID (PVID) to the host VLAN ID 1.
Syntax
clear port vlan port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the Fast Ethernet ports 3 and 11 in module1 to a VLAN ID of 1
(Host VLAN):
Matrix(rw)->clear port vlan fe.1.3,fe.1.11

show vlan interface

Use this command to display the MIB‐II interface entry mapped to a VLAN.
Syntax
show vlan interface [vlan-list]
Parameters
vlan‐list
Defaults
If vlan‐list is not specified, MIB2 interface entries will be displayed for all VLANs.
Specifies the port(s) to be reset to the host VLAN ID 1. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
(Optional) Displays the MIB2 interface entry for specific VLAN(s).
Enterasys Matrix DFE-Gold Series Configuration Guide 7-11
Assigning Port VLAN IDs (PVIDs) and Ingress Filtering