Show Macauthentication Session - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring MAC Authentication
Table 25-2 show macauthentication Output Details (continued)
Output...
Port
Port State
Quiet Period
Reauth Period
Auth Allowed
Auth Allocated
Reauthentications

show macauthentication session

Use this command to display the active MAC authenticated sessions.
Syntax
show macauthentication session
Parameters
None.
Defaults
If port‐string is not specified, MAC session information will be displayed for all MAC
authentication ports.
Mode
Switch command, Read‐Only.
Example
This example shows how to display MAC session information:
Matrix(rw)->show macauthentication session
Port
-----
ge.1.2
Table 25‐3 provides an explanation of the command output.
25-28 Authentication Configuration
What it displays...
Port designation. For a detailed description of possible port-string
values, refer to
Whether or not MAC authentication is enabled or disabled on this port.
Enables a reauthentication attempt for failed entries at the period
specified in seconds. Default value is 0 (never).
Reauthentication period for this port. Default value of 30 can be
changed using the set macauthentication reauthperiod command
described in
Number of concurrent authentications supported on this port. Default is
1 and cannot be reset.
Maximum number of MAC authentications permitted on this port.
Default is 1 and cannot be reset.
Whether or not reauthentication is enabled or disabled on this port. Set
using the set macauthentication reauthentication command
described in
MAC Address Duration
----------------- ---------- -------------
00:60:97:b5:4c:07 0,00:52:31
"Port String Syntax Used in the
"set macauthentication reauthperiod" on page 25-35.
"set macauthentication reauthentication" on page 25-34.
Reauth Period Reauthentications
-----------------
3600 disabled
show macauthentication session
CLI" on page 4-2.