Clear Spantree Txholdcount; Show Spantree Maxhops - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Bridge Parameters
Example
This example shows how to globally set the transmit hold count to 5:
Matrix(rw)->set spantree txholdcount 5

clear spantree txholdcount

Use this command to reset the transmit hold count to the default value of 6.
Syntax
clear spantree txholdcount
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the transmit hold count:
Matrix(rw)->clear spantree txholdcount

show spantree maxhops

Use this command to display the Spanning Tree maximum hop count.
Syntax
show spantree maxhops
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the Spanning Tree maximum hop count:
Matrix(rw)->show spantree maxhops
Bridge Max Hop count is set to 20
6-34 Spanning Tree Configuration
clear spantree txholdcount