Clear Spantree Spanguardtrap Enable; Show Spantree Backuproot - Enterasys Matrix DFE-Gold Series Configuration Manual

clear spantree spanguardtrap enable

clear spantree spanguardtrap enable
Use this command to reset the Spanning Tree span guard trap function back to the default state of
enabled.
Syntax
clear spantree spanguardtrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the span guard trap function to enabled:
Matrix(rw)->clear spantree spanguardtrapenable

show spantree backuproot

Use this command to display the state of the Spanning Tree backup root function.
Syntax
show spantree backuproot [sid]
Parameters
sid
Defaults
If sid is not specified, status will be shown for Spanning Tree 0.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the status of the backup root function on SID 0:
Matrix(rw)->show spantree backuproot
Backup Root is set to disable on sid 0
(Optional) Displays status for a specific Spanning Tree. Valid values are
0 ‐ 4094. If not specified, SID 0 is assumed.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-41
Configuring Spanning Tree Bridge Parameters