Set Garp Timer; Clear Garp Timer - Enterasys Matrix DFE-Gold Series Configuration Manual

set garp timer

Example
This example shows how to clear GVRP status globally on the device:
Matrix(rw)->clear gvrp
set garp timer
Use this command to adjust the values of the join, leave, and leaveall timers.
Syntax
set garp timer {[join timer-value] [leave timer-value] [leaveall timer-value]}
port-string
Parameters
join timer‐value
leave timer‐value
leaveall timer‐value
port‐string
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
The setting of these timers is critical and should only be changed by personnel familiar with the
802.1Q standards documentation, which is not supplied with this device.
Examples
This example shows how to set the GARP join timer value to 100 centiseconds for all ports:
Matrix(rw)->set garp timer join 100 *.*.*
This example shows how to set the leave timer value to 300 centiseconds for all ports:
Matrix(rw)->set garp timer leave 300 *.*.*
This example shows how to set the leaveall timer value to 20000 centiseconds for all ports:
Matrix(rw)->set garp timer leaveall 20000 *.*.*

clear garp timer

Use this command to reset GARP timers back to default values.
Syntax
clear garp timer {[join] [leave] [leaveall]} port-string
Sets the GARP join timer in centiseconds (Refer to 802.1Q standard.)
Sets the GARP leave timer in centiseconds (Refer to 802.1Q standard.)
Sets the GARP leaveall timer in centiseconds (Refer to 802.1Q standard.)
Specifies the port(s) on which to configure GARP timer settings. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Enterasys Matrix DFE-Gold Series Configuration Guide 7-27
Enabling/Disabling GVRP